Genmar

Quality handlebar risers for modern sports bikes  Stop Sports bike back ache!

GenMar Manufacturing was founded in 1986 by Gene Waggoner, a motorcycle racer and enthusiast. Their handlebar risers are machined from billet aluminum.  Shaped like the base of your handlebar mount, they will raise the handlebars upward and back (due to the fork angle), still leaving the motorcycle with a very stock look.  Most riders will have to sit on the bike to notice there is something different.  Raising to bars up even a mere 3/4" makes a huge difference in the weight on your hands. 

Raising your bars with a spacer design, like our handlebar risers, you raise the bars but still retain the stock angle.  This is very important to maintaining even weight distribution across you hands during braking and turning.  The GenMar Handlebar Riser is designed to raise your handlebars the maximum your motorcycle will allow.  The handle bars will not hit the fairing or the tank when turned full left or full right.  There is no need to remove or change any of the control on most models. Most installations can be completed in as little as 15 minutes. 

!

Honda Risers

From
!
Depending on model these may have to be placed on top the triple clamp or on the bars themselves. The amount raised also depends on model. Please call or email for particular model details.

Kawasaki Risers

From
!
Depending on model these may have to be placed on top the triple clamp or on the bars themselves. The amount raised also depends on model. Please call or email for particular model details.

Suzuki Risers

From
!
Depending on model these may have to be placed on top the triple clamp or on the bars themselves. The amount raised also depends on model. Please call or email for particular model details.

Yamaha Risers

From
!
Depending on model these may have to be placed on top the triple clamp or on the bars themselves. The amount raised also depends on model. Please call or email for particular model details.

Aprilia Risers

!
 The risers are placed between the fork crown and the handlebars to raise the bars up 1" (25mm). This will help to relieve wrist and neck pain on long rides. Requires no change of any control cables, wiring, or hoses.

Ducati Risers

!
These designed to fit only the 1 1/8" diameter bars. The risers are placed between the fork crown and the handlebars to raise the bars up 1 1/4" (31mm) and back 3/4" (19mm). This will help to relieve wrist and neck pain on long rides. Requires no change of any control cables, wiring, or hoses.